How to Install AiM Race Studio 3: Setup Guide for MyChron, Solo, MX & SmartyCam

Installing AiM Race Studio 3 correctly the first time saves a lot of frustration on race day. This guide walks through the practical setup process for AiM's data software, which is used across the MyChron, Solo, MX, EVO, PDM and SmartyCam ranges.

Before You Start

• Confirm the exact AiM device model and, where relevant, its firmware version. Race Studio 3 supports a wide range of AiM hardware, but the exact features and connection method depend on the device.
• Use a computer that meets AiM's current published system requirements for Race Studio 3.
• Close any other software that might use the same USB, Wi-Fi, or Bluetooth connection as your AiM device.
• Have your AiM connection cable or dongle on hand, or confirm your device's Wi-Fi download capability if it supports wireless transfer.

Step 1: Download the Correct Installer

Always install Race Studio 3 from AiM's official current software source rather than an older file saved from a previous computer. Using the internal AiM Software Downloads support section keeps you pointed at the right current source.

Step 2: Run the Installation

Run the installer with administrator rights on your computer. Accept the driver installation prompts if offered. These drivers are what allow your computer to recognise a connected AiM device over USB.

Step 3: Connect Your AiM Device

Connect your MyChron, Solo, MX, EVO, or SmartyCam device using the correct AiM cable or interface for that model. If your device supports Wi-Fi transfer, follow the specific pairing steps for that device instead of a USB connection.

• Power the device on before or during the connection, depending on the model's own instructions.
• If the device is not detected, try a different known-good cable and a direct connection rather than through a USB hub.
• Restart Race Studio 3 after the first successful connection to confirm the device is recognised consistently.

Step 4: Set Up the Device Configuration

Once connected, Race Studio 3 will let you view and edit the device's configuration: sensor channels, units, display pages, alarms, and (where applicable) GPS and track settings. Save a copy of the working configuration once you're happy with it, before making further changes.

Step 5: Confirm Data Download Works

Run a short test session, then confirm you can download it into Race Studio 3 and open it for review. Confirming this before race day avoids discovering a connection or driver issue when you actually need the data.

Common Installation Issues

The device is not detected after installation

Check the cable, the USB port, and that the correct drivers installed during setup. Try a different computer if the issue persists, to isolate whether it's the device or the computer.

Race Studio 3 will not open or crashes on startup

Confirm your computer meets AiM's current system requirements, and that you have installed the latest Race Studio 3 version rather than an old installer.

Wi-Fi download will not connect

Confirm the device's Wi-Fi is enabled and that your computer is connected to the correct network or direct device hotspot, depending on how that AiM model's Wi-Fi transfer works.

Frequently Asked Questions

Do I need a different Race Studio 3 install for each AiM device?

No. One Race Studio 3 installation on your computer works with all supported AiM devices; the software recognises the connected model.

Can I install Race Studio 3 on more than one computer?

Yes, there's no restriction on installing it on multiple computers you use, such as a race trailer laptop and a home computer.

Do I need to reinstall Race Studio 3 when I get a new AiM device?

Usually not, if your existing installation is a current version. Check for a software update if the new device isn't recognised.

Continue Your Race Studio 3 Setup

Once Race Studio 3 is installed and your device connects reliably, head back to the AiM Race Studio 3 Knowledge Hub for configuration, data analysis, channels, and troubleshooting guidance.