Race Studio 3 Software

The Harris-hosted Race Studio 3 installer will be listed here once the approved software file has been supplied or authorised for distribution by the appropriate rights holder.

Until then, use the internal installation and workflow guidance and confirm your exact device, operating system, and supported software version before installation.

AiM Firmware Downloads

Model-specific firmware files will be listed here only after they have been verified and approved for Harris Race Radios distribution. Do not install firmware intended for another AiM model or configuration.

Before any firmware update:

• Identify the exact AiM product and current firmware version.
• Save the current configuration and download important sessions.
• Use reliable power and the correct connection method.
• Read the update instructions for the exact product.
• Allow time to test the complete system before a race or event.

See the internal Race Studio 3 firmware guidance.

Products Covered by This Support Area

• AiM MyChron: kart dashes, lap timing, GPS, sensors, and session data.
• AiM Solo: lap timers, GPS data, reference laps, and driver analysis.
• AiM SmartyCam: camera, data overlay, and synchronised video workflows where supported.
• AiM MX and EVO: vehicle data logging, channels, ECU information, and race engineering.
• AiM PDM, ECU, CAN, and sensors: more complex vehicle and data-system installations.

Internal Setup and Support Guides

• Race Studio 3 configuration guidance
• Connecting AiM devices
• Downloading and analysing AiM data
• Race Studio 3 troubleshooting
• AiM MyChron Knowledge Hub
• AiM Academy Training Videos

Need a Race Studio 3 File or Update?

If you need a specific software installer, firmware file, cable, sensor, or configuration answer, contact Harris Race Radios with the exact AiM model and application. We will confirm what is appropriate before you change a race-critical system.